on 01-31-2007 9:52 PM
I am modifying a custom workflow. I added a step (a user decision) and then decided that I did not need the step. I removed (or thought I removed) the step from the workflow graphic display. But when I save and check, I see these steps being referenced in warnings that are being created. "This node violates the block structure required". The suggested solution for this error is to do a Block Correction. This causes a dump.
How can I get rid of these steps - when I cannot find them in my workflow but they are still referenced ?
Hi Sheri,
Check if 422334 note applies to your system level.
Do you have a previous version of the workflow ? If so you
could use this and delete the steps (do not do this in the graphical
builder) and save and see if this works.
Best regards,
Dolores
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sheri,
I had the same warnings in a custom workflow. But when I ran Block Correction, the warnings disappeared.
If you are getting short dumps, I presume you've searched OSS for notes relating to the short dump?
Maybe you could post the contents of the dump here.
regards
Para
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
93 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.