Unable to convert sender service to an ALE logical system

[Former Member]

Hi,

I am doing file to Idoc scenario and got the below error.

"Unable to convert sender service to an ALE logical system"

Can anybody tell what causes for this error?

Thanks

Chiru

[Former Member]

Hi,

The Partner Profile should be with respect to the Logical System Name.

Internally, during runtime, IDOC adapter fills up the IDOC control record with the corresponding Logical system names for the sender partner (SNDPRN) and Receiver Partner (RCVPRN) . If your Business Systems have the correct logical system name assigned to them and you can see the same in Business System--> Adapter Specific Identifiers.

These links will definitely help you to get the Concept right.

Check Michel Krawczyk’s

Mastering IDoc Business Scenarios with SAP XI

And

/people/prateek.shah/blog/2005/06/08/introduction-to-idoc-xi-file-scenario-and-complete-walk-through-for-starters

/people/ravikumar.allampallam/blog/2005/02/23/configuration-steps-required-for-posting-idocsxi

Regards.

[Former Member]

Hi,

Check the Logical system name in SLD for your Business system of FileService is same as the Partner Name for Idoc.

Also check if this is updated in ID .

Bipin

Message was edited by:

Bipin Chandra Joshi

[Former Member]

How to check the partner name for Idoc? using TC we20?

I have given Logical names for sender business system and for receiver business sytem (R/3) in SLD.

Thanks

Chiru

[Former Member]

When I see the sender service FROM Integration Directory, BS_CISCO (sender service) -> Service -> Adapter specific identifiers :

LS- LS_CISCO

And i see blank for R/3 system details. Is this a problem?

Pls. help me gurus. I am at elementary stage.

Thanks

Chiru

[Former Member]

No Need to fill up R/3 system details

Bipin

[Former Member]

Thanks Bipin.

[Former Member]

hey

in SLD, make sure that the sending business system has a logical system name.

Then in ID, go to the business sytem in change mode, then pull up menu Service-Adapter Specific Identifiers. If Idoc adapter LS is blank, click the button to get it from SLD. Then click Apply

thanx

ahmad

Pl:reward with points for helpful answers