12-07-2006 10:16 AM
Does the Profile Parameter rsau/enable have to ="1" for the audit log to be active or is this parameter set to purely allow the maintainance of static profiles. I have been reading into SAP's documentation and they only refer to this parameter in the "Maintaining Static Profiles" section. Therefore I would like to know if the audit log can record when the parameter rsau/enable = "0"?
Many thanks
12-07-2006 10:39 AM
I think this is mentioned in SAP note 539404.
See also the search hits on SM19.
Cheers,
Julius
12-07-2006 10:39 AM
I think this is mentioned in SAP note 539404.
See also the search hits on SM19.
Cheers,
Julius
12-07-2006 4:05 PM
>> I think this is mentioned in SAP note 539404.
Like many solutions, it is described as a problem... Question No. 20.
Cheers,
Julius
12-07-2006 10:40 AM
Hi
I have it running on my NW2004s sneak peak system, whit a dynamic filter and the rsau/enable = 0. So Yes - it's possible to record in the secure audit log with rsau/enable = "0", if your using the dynamic filters
Regards
Morten Nielsen