cancel
Showing results for 
Search instead for 
Did you mean: 

Call Visual Composer via url with parameters

Former Member
0 Kudos

Is it possible to call the Visual Composer application via url with dynamic parameters - like Web Dynpro appliacitons ?

As of SPS8 we can use Portal Eventing to pass parameters between iviews - but have not seen the capability to start from a url with parameters.

Is this feature going to be supported in a future release or Support Pack???

Thanks

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Yes, we already had that and have even a Visual Composer WIKI entry:

https://wiki.sdn.sap.com/wiki/display/VC/LaunchingVCwithURLparameters

sap_cohort
Active Contributor
0 Kudos

It's not clear what you have to do. Could you give a little more detail? I created a start point and added the parameter I want. How do I reference the incoming parameter? It doesn't show up as available anywhere.

Thanks again!

Former Member
0 Kudos

Hi Kenneth,

Have you managed to sort this problem? If so can you share it?

Thanks,

Answers (1)

Answers (1)

former_member193545
Active Participant
0 Kudos

Hi

This can be done but only on VC iviews with start points.

This has to be done using a specific syntax. I am pretty sure there was a forum entry concerning this, but if there is not I will create a blog concerning this.

Jarrod Williams