local adapter engine

[Former Member]

already we have central adapter engine then wat is the use of local adapter engine?

[bhavesh_kantilal · Accepted solution]

Hi,

Local Adapter Engine is used when you need Load Balancing or Fail Over Adapter Engine in case of Disaster Recovery and so on.

Regards,

Bhavesh

[Former Member · Accepted solution]

hi bhavesh

so where we install this local adapter engine..

[Shabarish_Nair · Accepted solution]

the local adapter engine is installed on any system that will run on WAS !!!

[bhavesh_kantilal · Accepted solution]

Hi,

This local adapter engine can be installed on any WAS and then while creating the Adapter in the Integration Directory yu can select the adapter engine from your central or local adapter engine.

ofcourse all the installation activities like registring the adapter engine , etc should be done before you will be able to see the adapter engine listed in the integration directory as well.

Regards,

Bhavesh

[Former Member · Accepted solution]

Hi Bhavesh,

<i>ofcourse all the installation activities like registring the adapter engine , etc should be done before you will be able to see the adapter engine listed in the integration directory as well.</i>

Can you please explain how to do the registration of a non-central adapter engine.

I have a non-central adapter engine. But I am not able to see any adapter engine during Channel creation in ID.

If I reinstall PI does the central adapter engine gets installed?

Regards,

Jitendra