on 11-20-2006 5:44 AM
Hi All,
I wanted to know whether it is possible to trigger alerts if an error occurs in the communication channel.If yes,how do I go about it?
Thanks and Regards,
Jishi
i think the only way to configure alerts install CCMS.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
HI,
please look at following
http://help.sap.com/saphelp_webas610/helpdata/en/fb/e59e38fdd5363ce10000009b38f839/content.htm
/people/sap.india5/blog/2005/12/06/xi-ccms-alert-monitoring-overview-and-features
/people/sap.user72/blog/2005/11/24/xi-configuring-ccms-monitoring-for-xi-part-i
/people/sap.user72/blog/2005/12/05/xi-grmg-customizing-for-xi-ccms-heartbeat-monitoring-part-ii
Thanks,
Tuhin
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi ,
If you are on
SP12 : there is no way for u to raise alerts
SP13 : you can configure CCMS to raise alerts for AE
Sp14 on wards :you have the option of specifying adapter alert rules.
Sekhar
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Jishi,
The ALERTS are triggered automatically by the AE/IS engines in case of error.
Via the ALERT rules, you can either ignore the alerts or have them e.g. delivered by e-mail to an administrator.
( see SXMSALERT_LOGREADER to see the triggered alerts and how it is handled )
You can't define an alert rule for a specific channel, but you usually achieve the same by using all the other criteria ( sender details / receiver details / adapter type )
rgds
Dirk
Hi,
I have created the Alert category and alert rule for adapters in the 'Where did the error occured' part.Is there any other configurations that have to be done for raising this particular type of alerts(Communication Channel Errors).Other alerts triggered from the BPM and all are workin for me,but when there is a red status in the CC,no alerts are triggered.what could be the problem?
Thanks,
Jishi
Hi,
For Alert rules configuration:
Remove the Check from Suppress Multiple Alerts of this Rule
For where did the error occur, see that you have selected Radio button with 'No Restriction
When creating the Alert Category, have u put some parameters in Container tab and Long and Short text.
If allt he above is done check if you have any dumps in ST22.
Regards
Vijaya
Hi Vijaya,
Now the alerts are getting triggered.I have given the dynamic text indicator checked in ALRTCATDEF.But a blank alert is being generated and sent.I am using this alert to inform if a problem in any of the Communication Channel that I am using.What could be the problem?
Thanks
Jishi
Message was edited by:
Jishi Abraham
User | Count |
---|---|
93 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.