on 11-17-2006 8:52 PM
Guys,
I just need to grab a file from one system and place it to another one without changing a single byte of it, how can I do that?
Would I use the file adapter?
What data types?
I don't care what's in the file, but it's binary data and it's important not to change a thing.
Your help would be greatly appreciated!
Thanks a lot,
Viktor
You could do this several ways, depending on how you would like to configure your communication channels. But you can use a file adapter and when you are creating your interface determination you leave out the mapping information.
However, this is going to depend on how you would like to pick the file up, and how you would like to drop it off.
Message was edited by:
Harrison Holland
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
You can very well do it, We have did it,
With the help of File adapter in sender side and receiver side we can acheive it, We did it so that we can track the file END to END . From R/3 we made the report into file and with the help of file adapter we read and dropped into another 3 rd party file adapter.
Regards
Agasthuri Doss
In the end, the following weblog (from Felix) helped me the most:
/people/sap.user72/blog/2005/07/15/copy-a-file-with-same-filename-using-xi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
HI,
Check out this blog -
/people/shabarish.vijayakumar/blog/2006/04/03/xi-in-the-role-of-a-ftp
Hope this helps,
Regards,
Moorthy
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
101 | |
13 | |
13 | |
11 | |
11 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.