DSM Terminator problem

[david_fryda2]

Hi everyone,

I am getting this DSM Terminator window popup when I close any of my WD application. I thought it was because those RFCs calls that I make but it isn't related. I created a simple HelloWorld project, created an iView and a Page.

When I preview the page from the Prtal and close it, I get the DSM terminator popup window.

How can I get ride of this popup window ?

How is it that when I "deploy and run" the application from the NWDS04S and close the application, I do not get the DSM Terminator message ?

Thanks for the help.

Regards.

[lajitha_menon · Accepted solution]

Hi David,

DSM Terminator is used to close sessions by the portal.

Have a look at the following threads

https://forums.sdn.sap.com/click.jspa?searchID=24853&messageID=171711

https://forums.sdn.sap.com/click.jspa?searchID=24853&messageID=728377

https://forums.sdn.sap.com/click.jspa?searchID=24853&messageID=459394

https://forums.sdn.sap.com/click.jspa?searchID=24853&messageID=980709

Regards

Message was edited by:

L Menon

[david_fryda2 · Accepted solution]

Hi Menon,

If I understand well, this is a configuration issue and not a programming issue ?

Thanks.

Regards.

[lajitha_menon · Accepted solution]

Hi David,

Thats right. I understand it is used by the session release agent on the portal. Have a look at the following notes and related notes as well for problems in SRA.

Note 596698 - Session Release Agent - Typical Problems & Troubleshooting

Note 755947 - Session Release Agent - Guest Access

Hope this helps,

Regards,

LM

[david_fryda2 · Accepted solution]

Thanks Menon for your help!

Regards.

PS : So, it is not related to use of WDClientUser.forceLogoffClientUser() ?

Message was edited by:

David Fryda