Problem: using Dynamic file naming in adapter

[subrai]

Hi

Wat i m doing is using dynamic file configuration as given in this link

/people/michal.krawczyk2/blog/2005/11/10/xi-the-same-filename-from-a-sender-to-a-receiver-file-adapter--sp14 and trying to get file name and content of the file.

I m getting file name in dynamic configuration in SXMB_MONI but payload is empty.Actually i have to pass this payload to BPM.

[bhavesh_kantilal]

Subodh,

the problem is not very clear.

Can you give us the entire interface flow including the BPM flow.

Regards,

Bhavesh

[subrai]

Actually depending on the name of file i have to put some validations on data it contains. I have configured adapter specific properties.Is that makes situation clear to you?

[bhavesh_kantilal]

Subodh,

I understand that using the filename you would like to do the validations, but, am not able to get the entire flow, inclduing your BPM flow.

If you give us the entire interface flow, it would be helpful to understand the problem better.

Just a quick note : Try to do the mapping that gets the filename outside the BPM if you do not get this inside the BPM.

Have not tried this, but I have seen a few posts which found that the dynamic parametrs were not accesible inside the BPM.

Regards,

Bhavesh