on 10-09-2006 6:57 PM
Hi All,
I need help to build one scenario.
I am working on RFC->XI->JDBC->XI->RFC scenario. It is working fine.
But problem is that whenever JDBC server is down RFC is giving ABAP dump in SAP. How can i Remove ABAP dump in SAP and give information to RFC that "JDBC is out of order"
Is it possible to implement without BPM, then How?
If not possible then what could be the steps of BPM?
Thanks & Regards
closed
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi,
in a sync BPM you can do it very easily send step (jdbc)
and just wrap it into an exception branch
that will catch any jdbc excetion
and in the exception branch
you can put a mapping to the RFC.response "jdbc down"
Regards,
michal
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Michal,
Thanks for reply.
Please correct my BPM steps I am designing as follows:
1)Synchronous Receiver step to get RFC data in BPM
2) Synchronous Sender step inside Block to send & receive from JDBC
3) In side exception branch, A transformation step with RFC asynchronous receiver in target message
4) last sender step close bridge
Is above BPM is correct or any other BPM object needs to be add.?
Regards
ROhan,
TO achieve synchrnous BPM, you need to follow this approach as mentioned in the BLog
https://www.sdn.sap.com/irj/sdn/weblogs?blog=/pub/wlg/1403 [original link is broken] [original link is broken] [original link is broken] [original link is broken]
Regards,
Moorthy
Exception block with Transformation step which maps data into RFC.res will solve your problem.
Also just to get an hint , on exception branch-
http://help.sap.com/saphelp_nw2004s/helpdata/en/33/4a773f12f14a18e10000000a114084/content.htm
Regards,
Moorthy
Rohan,
1.Recive Step should open the Synch - Asynch Bridge
2. Block Step --> Send Synchronous inside this step with an Exception Hanler.
3. Now in the exception ahndler step, do the necessary error handling requirement.
4. Send Step --> closes Synch Asynch bridge.
My question is what data do you want to send back to the RFC if the DB is down? This data should be populated inside the exception handling block and then this data should be mapped to the corresponding RFC response and used in the step 4.
Regards,
Bhavesh
User | Count |
---|---|
91 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.