cancel
Showing results for 
Search instead for 
Did you mean: 

IDOC To FILE

Former Member
0 Kudos

Hi

In Idoc to file scenario, i did the design and configuration part. When i selected the material (bd10) in R/3 and executed it. I was unable to monitor in runtime. In RTWB it is not displaying my receiver. can anybody help me.

Thanks

sriram

Accepted Solutions (0)

Answers (3)

Answers (3)

moorthy
Active Contributor
0 Kudos

HI,

1)First check the status in transaction WE02 in R/3 ..And check is the idoc has been sent successfully

2) If step 1 success then go to transaction SM58 in R/3 and check the tRFC queues

3) If it sucess , then go to transaction SXMB_MONI in XI , and check the status of the message.

To debug- http://help.sap.com/saphelp_nw04/helpdata/en/6a/e6194119d8f323e10000000a155106/content.htm

Hope this helps to analyse the errors.

Regards,

moorthy

Former Member
0 Kudos

these blog is better for you:

/people/ravikumar.allampallam/blog/2005/02/23/configuration-steps-required-for-posting-idocsxi

/wojtek

Former Member
0 Kudos

hi,

1. please check sm58 in your source system. maybe there are some errors

2. check your partner profile

3. check if you have assigned correct logical system in sld

4. check your port configuration in idx1

regards,

wojtek

Former Member
0 Kudos

here you have a webblog:

/people/prateek.shah/blog/2005/06/08/introduction-to-idoc-xi-file-scenario-and-complete-walk-through-for-starters - IDoc to File