on 09-21-2006 6:44 PM
Hi,
I am working on SP16 and I would mapped file to RFC as 1:N called multimap.
I could able to test(at MM & IM) and created multi bapis using request payload from moni. But i couldn't able to call BAPI at runtime.
The BPM mapping moni showing Message_Out had 1 entry(at technical details) , but it couldn't show any message when i open that.
The graphical workflow showing every thing green.
I understand transfermation step unable to send mapping to send step!
I tried with different BPMs for multimap, but both are failing to call at same step:
1. Recstep>Trans(IM is 0:U)>Loop((container)&(send))
2. Recstep->Trans(IM is 0:U)->block(send)
Note: trace file not showing any error .
Does any note could helpout for me? let me know if you need screen shots of my dev..then i could send it to ur personal ids..!
Thanks,
Sankar!
Hi,
Why can you try Multimapping without BPM if you dont have any other steps other than just receiving and sending to RFC.
In the BLOCK step did you set ParForEach.
Thanks,
Prakash
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Were you able to confirm that RFC is called N times. How are you saying it is called only one type. How is your BPM steps. Where is your Send step to RFC I think its inside the Block right. Where is your Mail Send step? It should be inside the same Block. Hope you have done that.
To see Messages in SXMB_MONI go to SXMB_ADM --> Integration engine Config and set LOGGING =1
Thanks,
Prakash
Prakash,
my runtime logging value 1 only..!!
and Still i need to redisgn BPM for fil>rfc>mail..
current my BPM for testing for file-->rfc!(i dint put the send step for mail)
the sendstep which is inside of block is send to rfc.
>>Were you able to confirm that RFC is called N times.
its based on my multimap(successfully checked with MM& IM), which i have given at transformation step.
BPM steps:
-
Recive(FILE_ABS)
Transfor(IM: file_abs2BAPI_ABS,Soumsg: FILE_ABS, Tarmsg:BAPI_ABS(multiline)
Block: parForEach, multiline: BAPI_ABS(process), currentline:BAPI_ABS(block)
Sendstep: BAPI_ABS(process)
Let send ur mail id..ten i could send screen shots..hop it will give clear idea abt that..!!
Thanks,
Sankar!
User | Count |
---|---|
91 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.