Error during startup of EHPI Enhancement Package Installer

[MarcelRabe]

Hi,

i'm about to install EHP2 for NW7.0 on top of an existing NW7.0 installation (Usage Type Portal). I've unpacked the EHPI software but when I run the STARTUP command the following happens:

Mar 7, 2012 1:55:59 PM [Info]: Initializing SecurityManager ...

FILE: [62] 13:56:50 ***ERROR (sapjvm_oswrp.cpp:2128): fd=41: close failed (9).

Mar 7, 2012 1:56:55 PM [Error]: IOException: Bad file number

key generation timed out

Mar 7, 2012 1:56:55 PM [Fatal]: Unable to initialize ServerSecurityManager.

Mar 7, 2012 1:56:55 PM [Fatal]: Exiting

Thus the EHPI doesn't startup. Any thoughts on how to fix this? Is there a timeout parameter I can set?

thanks

Marcel

[nirmal_konchada · Accepted solution]

Hi,

Try deleting the below file and start EHPI.

EHPI/sdt/data/.sdt_keystore

start EHPI with ./STARTUP jce_policy_zip=jce_policy-1_5_0.zip

Let me know if you still face any issue.

Regards,

Nirmal.K

[MarcelRabe · Accepted solution]

Hi Nirmal,

thanks you for your quick response. This is what the installer returns when I use your suggested command:

Mar 7, 2012 2:35:56 PM [Error]: The parameter jce_policy_zip in externally supplied configuration is invalid.

I looked up the parameters for the STARTUP:

rootdir [guiport] [httpport] [guistart] [guimode] [config] [sid] [instanceNr]

Thus the jce_policy_zip is not a valid parameter.

However, after deleting the file specified I could just run STARTUP again and this worked.

Thanks

Marcel

Edited by: M. Rabe on Mar 7, 2012 2:57 PM