Not able to save s-user in sap assingment

[Former Member]

Hi,

While assigning username and customer number and contact person in aisuser t-code. Its not saving and giving error as below.

does not exist in AISAPCUSTNOS (check entry)

Thanks in advance

[Former Member · Accepted solution]

Hi,
>            While  assigning username and customer number and contact person in aisuser t-code. Its not saving and giving error as below.
> 
>  does not exist in AISAPCUSTNOS (check entry)
> 
> 
> Thanks in advance

Hi, basisguy2012.

To be able to use the basic SAP Solution Manager functions you are to maintain your SAP customer number(s).

Go to SPRO -> SAP Solution Manager -> SAP Partner -> Basic Setup for Several SAP Customer Numbers -> Maintain SAP Customer Nubmers (or go to SM30 -> V_AISAPCUSTNOS).

Here you can maintain the Custoner Number of your organization. After this step you'll be able to maintain S-User in AISUSER.

[Former Member · Accepted solution]

Thanks a lot...

I have maintained only username and sap customer number and left blank with contact person,

when i am saving its now displays error as below :

Partner 00000000000 not found - see long text.

[Former Member · Accepted solution]

Thanks  a lot...
>  
> I have maintained only username and sap customer number and left blank with contact person,
>  when i am saving its now displays error as below :
> Partner 00000000000 not found - see long text.

Due to Configuration Guide of SAP SM 7.1:

"6.17 Message u201CPartner 00000 not found u2013 see long textu201D is displayed while saving entries in the AISUSER Table

This is a warning which can be ignored. Select u201Centeru201D and proceed.

This is a warning which can be ignored. Select u201Centeru201D and proceed."

So you can ignore this warning.

[Former Member · Accepted solution]

Hi,

Normally you could see this type of warning more places in solman configuration,

Just simply click on green tick mark which is left to command field and procceed. this should save and allow you to navigate furhter in the page.

Check and update

Thanks

Jansi

[Former Member]

Hi,

Please check below Wiki:

http://wiki.sdn.sap.com/wiki/x/cweUDw

Are you configured to handle multiple customer numbers.

However, the view V_AISAPCUSTNOS may not maintained correctly.

Check if it is maintained with S-user ID info instead of customer number or not?

Please delete the old entries on S-user ID in view V_AISAPCUSTNOS and addd corect entries.

Upon executing transaction code AISUSER, you should see the

column "User" and "Contact Person".

The "User" column should have the logon user id defined whereas

"Contact Person" is the corresponding S-user ID.

It should be set with your S-user ID without the "S" and the preceding

zero.

eg. if logon id to the system is ABCDEF and S-user id is S0001234567,

the following entry should be made in the column.

User Contact Person

ABCDEF 1234567

Thanks

Regards,

Vikram

[Former Member]

Thanks all, I have saved the data ignoring the warning..