on 02-28-2012 5:28 PM
hi,
Scenario : - i had two cap. categories A and B. Under A the cap groups a1, a2 etc., and under B the cap groups b1, b2 etc., are mapped. Now i changed the mappings of a1 and a2 to come under hte category B deleting the a1 and a2 under A. I ran the /RPM_FICO_INT_PLANNING for the entire data. i am getting "Group Instantiate" error in hte Planning and roll up mode. Also when i ran the integration mode(each item is linked to an internal order in FICO) it dumps.
Appreciate if anyone can suggest how could this be resolved.
Thanks
Hi Sujata,
Try executing the report /RPM/PLAN_INT_PREP and check if this solves the error.
Best Regards,
Priyatham
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Thanks again Priyatham
i first ran the program you mentioned(successfully) and it gave me no errors in /RPM/FICO_INT_PLANNING when on Planning and roll up mode. However, when i run it with integration it dumps and the error analysis shown as below.
-
Error analysis
The program "CL_DPR_FIN_GECCO_IAOM_SERVICESCP" contains the CALL FUNCTION
statement.
The name of the function module to be called is "IAOM_ACCOUNT_MANAGER".
No function module exists with the name "IAOM_ACCOUNT_MANAGER".
All function modules are listed in the Function Library (SE37).
-
Possible reasons:
a) Wrong name specified. Pay particular attention to
upper/lower case and underscores ("_").
or
b) Transport error
c) In the case of an enqueue/dequeue module,
the lock object may not have been activated
(ABAP/4 Dictionary).
-
pls reply.
User | Count |
---|---|
9 | |
7 | |
3 | |
2 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.