on 02-27-2012 12:44 PM
Hi Gurus ,
We are in SRM7.0 and ECC 6.0 Extended Classic Scenario.
1.The Middle ware settings are done correctly and product category is replicated without any error.
But when we are running DNL_CUST_BASIS3 system is throwing an error .
R3AM1 status shows running for a long time.
Analysis in dump ST22 shows the following message " An internal error in the database interface occurred during access to
the data of table "TCURF ".
2.Similarly when we replicate Material system is throwing the following errors in SMW01 .
**
Mat. for Initial Download: Table not supported by function
Conversion factors of base units of measure set to 1
Specify the relevant unit of length
Validation error occurred: Module COM_PRODUCT_MAT_VALIDATE, BDoc type PRODUCT_MAT.
**
Please reply
Kind Regards,
Suresh
Hello,
Check topic 2 of note 872533.
It mentions that objects DNL_CUST_BASIS* are not relevant anymore as of SRM 4.0.
In order to replicate unit of measures, note 451720 should be checked.
Regards,
Ricardo
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello,
Kindly follow the below steps to resolve the issue here.
1) Maintain the table TBLSYSDEST in both SRM and ERP system with regards to the logical system and Technical and Dialog rfc's.
Also assign the MW_admin in the rfc user.Register the queues with * smqr.
2) Follow the sap note 720819 and maintain all the 5 tables correctly.
3) Before you start the download, you must use transaction SE38 to execute the report BBP_PRODUCT_SETTINGS_MW in the EBP system. In the 'User' field, enter the consumer name that you
selected (for example, "SRM"). Select the radio button depending on whether service products should be active or not. The report starts with the default settings in test mode.
4) Ensure that the table CRMATAB in ERP system holds the entries after the step 1. IF it is blank then follow the sap note 1498111 and run the report SMOF_FILL_CRMATAB in SRM.
5) Also check for the R3-Guid in the tables CRMMLSGUID (SRM system) and CRMPRLS (ERP system ). Both should be identical with the logical system.
6) Also refer to the SAP notes 1548622 ; 1460623 ; 872533.
Kindly abort and load the object again, it should work fine.
Best Regards,
Rahul
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Please check following SAP Notes & Links:
Note 872533 - FAQ: Middleware
Note 402591 - Download Customizing object DNL_CUST_BASIS3
Note 1609476 - Error loading tables DNL_CUST_PRICE and DNL_CUST_BASIS3 from ERP.
Note 393939 - Table TCURX is not downloaded from R/3 System
Note 1038966 - Entries missing in TCURX after load of DNL_CUST_BASIS3
Link: http://forums.sdn.sap.com/thread.jspa?threadID=1925926
Regards,
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.