on 02-24-2012 5:27 AM
Hi,
I have followed the BPA set up guide and done all the configuration for BPA. I have set up BPMon for a solution and in the logical component node i have done configuration for many application monitors.
Also in the "Load Master Data" node the master data is loaded. But still in BPA when I am selecting the time frame and applying it I am getting a message that no data is applicable in the selected time frame.
How can i get the data in BPA.
Hi Vishal,
1435043 - E2E Workload Analysis - No applicable data found
specially section 3) EFWK Resource Manager Job, wehre you find several
hints to check this job and the EFWK Adminsitration.
Also check note: 894279 Background processing in SAP Solution Manager
Please have a look at following chapter of the the BPA Setup
guide to fully understand the data flow in this application:
2 Architecture of Business Process Analytics
> 2.1 Data Retrieval and Reporting
Please also review following chapter, in to see if there are any errors
extracting the data from the managed systems to SAP Solution Manager:
3.2.3 Checking status of Solution Manager Diagnostics Extractor
Framework (EFWK)
Also check:
1570282, 1643303 and 1602437
thanks
Regards,
Vikram
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Sometimes it requires patience I know in our case I needed to wait for the monitor to collect data few times to get data into BPA. If you don't have to deliver it until today, then I believe that there is a good good chance that on Monday morning data will be there.
BR
Jolanta
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Jolanta,
I think patience is required. But I am still not getting the data.
I have got 2 systems one is Solman 7.0 and the other 7.1. I Solman 7.0 BPA was already set up previously for one solution. after trying for sometime I am getting the data for that solution set up earlier but not for my new solution which I set up last week.
So the problem is that in 7.0 I am getting data of one solution which set up few months ago bu m not getting the data of the solution I set up last week. And in 7.1 I am not getting any data.
I dont think it should take this long to get the data.
Thanks
Edited by: Vishal Prajapati on Feb 27, 2012 10:19 AM
User | Count |
---|---|
84 | |
10 | |
9 | |
8 | |
6 | |
6 | |
6 | |
5 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.