on 02-23-2012 6:38 PM
Hi
Please share your thoughts on the following issue. Facing this Issue while doing mass replace MIC in QS27 transaction
{{
Message no. QP879
Diagnosis
There may be several reasons that lock indicators appear in the first column. For example:
The master inspection characteristic is unlocked and only used as a copy model.
The characteristic is not completely maintained.
A user exit is active (see Implementation Guide).
}}
I have maintained the MIC as Complete Copy model and maintained the MIC completely say "Unit of Measure" "Decimal Count" "Lower spec Limit" and "Upper Spec Limit" in the Quantitative data section of MIC.
This MIC is used in Two inspection Plans. The Limits are not changed in Inspection Plans. When I tried to replace the MIC with the new Version I am not able to select the Inspection Plans for Selection to Replace the MIC.
Regards
Raja
Mass replace will only replace full referecn MIC's.
It is not desinged to replace the copy model MIC's. By definition a copy model MIC is unlocked in the plan.
FF
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
97 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.