on 02-17-2012 1:04 PM
Hello consultant:
We have configurated GRC AC 10.0 RAR , when we executed risk analysis for Tx:NWBC , the system run analysis(foreground or background) correctly but when we executed analysis for Tx:SPRO->Governance Risk and compliance->Access control->Batch Risk Analysis , the system run two jobs E:GRAC_SOD and GRAC_SOD but the jobs run only 1 second and finished sucesffully but the system no run analysis.
Please could you help me?
Thank you very much
Hello Simon:
We have looked in ST22 and SM21 but we have not any errors.
We have looked via SPRO Monitor Batch Risk Anlysis but we have not any jobs executed
We have opened customer message to SAP and we are waiting for.
Thanks you very much.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Simon:
We have run the full sync job , then we have executed batch risk analysis , but in GRACUSERPRMVL table we have not contents and when we navigate NWBC Reports & Analytics tab we have not any graphics.
We have offline analysis set to "yes" in the configuration parameters
Thank you
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello:
We have tried to run offline analysis as a background job when we do it via SPRO.
GRCFND_a V1000 SP07(software component level)
Thank you
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
The SPRO way will only run the Batch risk analysis which populates the management dashboards (NWBC Reports & Analytics tab).
If you have offline analysis set to "yes" in the configuration parameters, it will also populate the offline content for the risk analysis but to access this information, you'll still need to go through NWBC.
The other SPRO based jobs are mainly synchronisation jobs which might only take a few seconds especially if you are running them in quick succession.
Simon
Hello Ajesh.
We have been generated SOD rules, when we executed risk analysis with Tx: NWBC , the sistem run analysis correctly but if the analysis have been executed from Tx SPRO , we do not obtain results.
Thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Esther,
Please check if you have generated SOD rules.
Regards,
Ajesh.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.