cancel
Showing results for 
Search instead for 
Did you mean: 

Change in Equipment status

Former Member
0 Kudos

Dear all,

I wish to perform tool calibration in my company. But QFOA_OBJECT_STATUS_SET function module in QM_PM follow up action is not working. I have done the following customization,

i) I have checked both afterposting and synchronous update check box.

ii) I have added the QM_PM follow up action in the selected set for catalog type 3 under the usage decision for calibration inspection.

iii)I have created an equipment under the category 'Q'.

I checked that function module in where used list by selecting all possiblities but it returns a message " Function module QFOA_OBJECT_STATUS_SET not found in selected search area.

What shall I do for trigerring that function module during usage decision? Kindly provide me the solution at the earliest.

Regards

Karthik

Accepted Solutions (0)

Answers (1)

Answers (1)

Former Member
0 Kudos

hi

check PRT view is maintained for the category Q

Regards

Seenu

Former Member
0 Kudos

Hi,

Without maintaining PRT view, PRT tab is not coming na and I have checked also PRT view is maintained for the equipment category Q.

Kindly provide me the solution for trigerring the function module.

Regards,

Karthik

Former Member
0 Kudos

Hello,

Check the below links.

http://www.sapfans.com/forums/viewtopic.php?f=27&t=215196&p=1053028

[SAP Note 502245|https://websmp230.sap-ag.de/sap(bD1lbiZjPTAwMQ==)/bc/bsp/spn/sapnotes/index2.htm?numm=502245]