ENTER AN EXPECTED VALUE error message for service lines

[Former Member]

Hi,

We are using SRM 7 with ECC 6.0.

The issue we are facing is when the SRM PO is replicated to ECC(We are changing the SERVICE PO to LIMIT PO after it replicated to ECC),the service lines get corretcly replicated as limit to ECC.

However if we delete the service line in SRM,the changes are also replocated fine to ECC.But after deletion of service lines,if we again change any other data in the PO,we see the error message SE999 "ENTER AN EXPECTED VALUE" because the NETPR for the limit item(which is actually service line in SRM) is ZERO after deletion of line.

AS per the ML90 config,this EXPECTED VALUE field is set as OPTIONAL.

Is there a way we can make this message a warning message via configuration?

Please advise.

[former_member208675]

Hi,

Can you give Expected Value in the same document. you might not see the message.

Expected Value is the total value of unplanned service.

Regards,

yaniVy

reward if helps