on 02-16-2012 12:25 AM
Hi
While Converting planned orders to process orders from APO to ECC, queues are not getting stop in Inbound ECC.. even after setting CIF user as dialog user and maintaining both CIF user and my user ids in /sapapo/c4 to block queues. maintained the same in ECC CIFGPARAMV table. Outbound queues are stopping in APO, but not able to debug APO outbound queues...
I want to debug user exit CIFORD03 (EXIT_SAPLCORD_005 ) in ECC . Please reply.
Thanks
Sreeni
Hi Sreeni,
The setting in /sapapo/c4 against your user ID would be relevant in this case.
Debugging should be on, and use detailed logging. Also, your RFC user ID should be a dialog user ID or a Service user ID.
Did you make sure that your user ID and the RFC user ID 'in R/3 for APO' have sufficient debug authorizations (including queue debug authorizations)?
(You can find out the RFC user in SM59 in APO against the RFC connection that you have for R/3. )
You should then see a queue stuck in R/3 inbound, where you could enter in debug mode.
If you go to SMQR in R/3, and see a queue called CF, then it's also possible to deregister this CF queue, and then queues will get stuck in R/3 inbound. You could then use this queue for debug if you have sufficient debug authorizations including queue debug.
Thanks - Pawan
Edited by: Pawan Pathak on Feb 16, 2012 1:32 PM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
The blog is very useful, thanks!
There are also here two comprehensive documents on CIF debug goo.gl/iiO7J and on CIF error analysis overall goo.gl/bgylt . You can see a preview to see if it suits your needs.
Cheers
Matthieu
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Srinee
This blog will help .
Rewards points if helpful.
Regards
Anant
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
You can enter into debug mode by writing a infinite loop in the begining of the user exit where you want to debug.
but you should be able to control when to activate the infinite loop by putting it in a if ..endif so that it not struck always.
once you execute the transaction in APO, you will be able to see your infinite loop in SM50/SM51
transaction and will be able to debug from there.
Let me know if this helps.
Thanks,
Ramesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
7 | |
4 | |
3 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.