Error:No receiver could be determined

[former_member223487]

Hi Experts,

While monitoring XML messages, I am getting one error "No receiver could be determined" for sender interface catalogupdatenotification_out. Please let me know how i can maintain receiver for this interface. I am SRM consultant and know very little about PI and we are not having any PI consultant this month.

Thanks for your help.

Regards,

Raj Saini

[Former Member · Accepted solution]

Hi Raju

As you are new go through the below link to understand a simple XI Scenario

http://www.sdn.sap.com/irj/scn/weblogs?blog=/pub/wlg/1345

specific to your error , you need to check why there are no receivers for the inteface , either there are filter conditions in Receiver determination which are not satisfied or your configuration scenario is cofigured in appropiratly ,refer above blogs and try to configure correctly,

Also for your reference , you can find a lot of information in the bleow link (may be its lot of information for you at this stage)

http://wiki.sdn.sap.com/wiki/display/XI/PI7.0and7.1Mapping-Blogs%2CArticles%2CWiki%2CCodeSamplesandVideos+Collections

Regards

$rinvias

[gagandeep_batra]

Hi,

>>> While monitoring XML messages, I am getting one error "No receiver could be determined" for sender interface catalogupdatenotification_out. Please let me know how i can maintain receiver for this interface. I am SRM consultant and know very little about PI and we are not having any PI consultant this month.

this type of error can cause by many way.such as

Receiver interface is not active

problem with Receiver Agreement

problem with input payload filed that Determine Receiver and Receiver Determination condition should not match etc.......

Regards,

Gagandeep

[former_member223487]

Thanks a lot everyone.

Regards,

Raj

[Muniyappan]

Hi,

please go through these links also which will help you to understand the simple scenario..

http://www.saptechnical.com/Tutorials/XI/File2File/page1.htm

http://www.saptechnical.com/Tutorials/XI/File2File/page6.htm

http://www.saptechnical.com/Tutorials/XI/File2File/page7.htm

And make sure Receiver determination along with condition based routing is active and is available in SXI_CACHE with status green.

If not reactivate the Receiver determination and, interface determination and both agreements.

Regards,

Muniyappan.

[MichalKrawczyk]

Hi,

>>>Please let me know how i can maintain receiver for this interface.

you need to do it in integration directory - there is a wizard there where you can select the sender system, sender interface, recever system, receiver interface and it will do the rest for you - try using this wizard

but if you don't have communication channels (or don't know where to send the message) you need to wait for a PI consultant

Regards,

Michal Krawczyk