on 02-09-2012 12:58 PM
When I enable wdisp/permission_table = PermFile in my web dispatcher it causes the web page to not be displayed at all...even with the entries of P * in the permfile (and no blank lines).
I can consistently take out the line wdisp/permission_table = PermFile and the web page is displayed.....then again put it back in the profile ....and again the web page is not displayed..?
I am only using P * as a test.....obviously we want to use D for some things later once we get past this error.
any ideas are helpful
thanks!
Linwood
Edited by: Linwood Doty on Feb 9, 2012 7:14 Pm
Wel, it seems we left off the .txt extension in the statement above.....after correcting that the permission table work quite well
left off the .txt on the permfile parameter entry...works now
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.