on 02-07-2012 3:29 PM
Dear All
We have a situation in a synchronous interface involving BPM.
IDoc <-> PI (BPM) <-> Legacy
We have observed that whenever an iDoc is triggered from SAP system it gets stuck in SMq2. These entries are cleared when we unlock the queues.
Same happens when the response from Legacy comes in. But at the final stage when BPM is pushing the response back to SAP system it gets stuck in TRFc. In moni we can see b/w flag but Outbound Status carries a green flag (Message Scheduled on outbound side)
When I go to SM58 I can see few entries with status text: Transaction Recorded . Each time i have to execute the LUW to clear it.
Is there anything wrong in the settings which is causing this.
I have done full cahe refresh but no help
Regards
Sourabh
hi,
once you have to check Queues are registered in sxmb_adm /not?
if not registered then follow bellow path:
SXMB_ADM->Manage Queues->Register queues->Activate Queues.
After doing this steps,then goto SMQ2->Select all the queues actiavte and unlock it.
Once u done all these steps,queues automatically will go.
(OR) refer from step 6 in below link
[help|http://help.sap.com/SAPHELP_NW04S/helpdata/EN/12/5dd23aaad7b3408dde3c1577fda5b3/content.htm]
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
>>>>We have observed that whenever an iDoc is triggered from SAP system it gets stuck in SMq2.
inside PI I assume ?
have you registered the queues in SXMB_ADM - register queues?
Regards,
Michal KRawczyk
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
101 | |
13 | |
13 | |
11 | |
11 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.