on 02-03-2012 10:28 AM
Hi Guru,
Thanks in advance, I have one issue in quality mgmt. How to copy the geometric symbols in the MIC, so that when result recording is carried out, the user can see the symbol, & based on the symbol he will get the exact information about the parameters that need to be check for values.?
Regards,
sharad
Can you not use the name of MIC as say:
you have diameter 10 to be checked with Quantitative MIC you can give name as Ø10 --> "Atl +0216 " (for Ø) .
etc.
same can be done in short text of MIC.
So while doing RR ,it will be helpful for the perople.
I hope this will add some value to your knowledge.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi I dont think it is possible only you can maintain it in the long text field.
Regards,
Smruti
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.