Interface Issuw

[former_member650236]

HI Experts,

I have an interface that receives a PO idoc from SAP and maps it to two

destinations

In production, I look at the two PO interface, I don't

see the Request Message Mapping node.

But I do see it in QA.

Is this a setting in my SXMB_MONI display? I have seen the output XML

payload in the past.

Any help will be appreciated,

Thanks in advance,

Valli

[Former Member · Accepted solution]

Hi,

Logging and tracing will not be enabled in Production system for performance improvements..

As these will do lot of operations ...and memory consumption...

HTH

Rajesh

[former_member650236 · Accepted solution]

Hi Rajesh,

Thanks for the prompt reply,

How can I achieve the Request Message Mapping node.Is there any different approach other than SXMB_ADM.

Any help would be appreciated,

Thanks,

Valli

[Former Member · Accepted solution]

Hi,

if you are looking for the mapping output then take the payload from the moni of production and execute the same at either DEv or QA Systems..

HTH

Rajesh

[former_member650236 · Accepted solution]

Hi Rajesh,

I am able to see the Response mapping node in QA.But not able to see in PRD. I want to see it in the PRD System.

How can I get this.

Thanks,

Valli

[Former Member · Accepted solution]

Hi Valli,

Enabling of Tracing and logging is not recommended for production systems..

but still if you need you have to configure the below parameters using

SXMB_ADM --> Integration engine configuraiton

1. Runtime Parameters -> Logging - set the value to 1.

2. Runtime parameter (trace_level) - set the value to 3.

HTH

Rajesh

[Former Member]

Hi,

You can also refer to the below link for more details :

[Former Member]

Yes, It is a setting in SXMB_ADM. But normally not activated in production environment. Please refer below link.

[http://www.saptechnical.com/Tips/XI/SXMB_MONI/Configure.htm]