on 01-24-2012 5:51 AM
Dear All
Question- We are developed (Z)Scrap process in ECC6
In scrap process,In backgroun rejected parts are moved From PR01 to
RJ01 (Mvt.type-131)
For some parts 04 Inspection type active, due to this parts are
directly not transfered in rjo1.For these parts Quality Inspection
lots are created.
We don't want Quality Inspection lots at the time of scrap.
Plz. give any suggesion
Can you make a copy of the 131 movement type, say 931? Then deactivate QM for 931 in config.
Now use 931 instead of 131 for your process.
FF
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Function module EXIT_SAPLQAAT_002 of customer exit QAAT0001
for example
if inspection type is '04' and storage location is 'RJ01', no inspection lot (e_no_inspection = 'X').
I would suggest you check more for this enhancement in this forum.
Regards, Do Wook KIM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
If you are using 131 mvt type then 04 inspection lot will be cretaed as this mvt type is configured for REM & not for scrapping .
If you do not want lot to create either deactivate 04 inspection type & use same process.
or
Change mvt type to say 551,201 etc without deactivating 04
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Deepali,
You are not Scrapping a Material, You are just transferring it to Scrap Location RJ01.
and as 04 insp. Type is active, and 131 Mvt is used, system generates an inspection Lot.
i think, by using 03 Insp. type will be beneficial.
you can transfer Scrap Qty to RJ01 without inspection lot.
Regards,
Amol
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.