Zebra printer and cutter

[former_member196079]

Hi experts

I have created a report for print labels, with some informations.

While printing, the zembra cuts every label, but i want to cut only after the last label.

How can i do this??

I've created a smartforms and sapscript, so both solutions are right.

Thanks in advance

Marco

[Former Member · Accepted solution]

Hi,

try to use ^MM (Print Mode - Cutter) command with ^MMC,N parameters

after last label. Follow ZPL documentation.

Regards,

--

Przemysław

[former_member196079 · Accepted solution]

Hi

Thanks for your reply.

Thi command must be inserted as text in sapscript??so i must insert ^MMC,N as text??.

I read the ZPL manual but i havn't found any for this issue.

You have an exaple??

best regards

Marco

[Former Member · Accepted solution]

Hi,

I use Link [ZPL-II-Prog.pdf|http://www.servopack.de/support/zebra/ZPLII-Prog.pdf] but I did not use this command before.

I have whole label in ZPL in SmartForm - I use all commands as text.

Regards,

--

Przemysław

[former_member196079 · Accepted solution]

I've tried, but i can't.

The zebra cut avery label, i can't cut only the last one...

any ideas?

Best regards

Marcp

[Former Member · Accepted solution]

Hi,

check also printer settings.

Maybe cutting is the default action after printing

- try to change it to feed label and invoke cutting by ZPL.

Regards,

--

Przemysław

[former_member196079 · Accepted solution]

Hi

There's no setting, but i can only activate, or deactivate the cutter,

if active it will always cut all label

[Former Member · Accepted solution]

Hi,

I working on Zebra printer without cutter - I can not verify this

- You can also try to disable cutting in ZPL (^{MMT,N = Tear-off) and for last label enabling it (}MMC,N).

Regards,

--

Przemysław