Copy inspection results

[ferran_mateohidalgo]

Hi experts.

I have a problem in this point. The problem is when I whant cretae de copy insppection results. I have not this option in the menu.

When I verify the configuartion all is activate.

Any segestion.

Thank you very much

[ferran_mateohidalgo]

HI,

The problem is that in Menu Bar -> Edit, there is option does not appear.

[former_member587434]

HI,
> 
> The problem is that in Menu Bar -> Edit, there is option does not appear.

Please try the followings.

1.

Start the transaction SE80

Enter the Function group QEEM

Goto the GUI Status E110, if the status is inactive, please press

Activate (Ctrl + F3)

2.

Please make sure that BAdIs QEC_RESULT_COPY QEC_SELECTION and

QEC_MAPPING are implemented on your system.

Pleas also refer to the SAP note 596648 which holds further information.

[former_member221025]

Hello,

I think your problem is you are unable to find "Copy inspection results" command while Result recording.

It has to be there in Menu Bar>Edit. It may be greyed out. (If you do not have configured)

you can also get it in Results recording table. there is a column named "Origin Results data".

Regards,

Amol

[Former Member]

Refer

http://www.sdn.sap.com/irj/sdn/go/portal/prtroot/docs/library/uuid/60221c69-0f8b-2b10-eebf-bec51a601...

and

[Former Member]

Hi

you can check for the following settings. If you maintain same quality plan for both the inspection type there should not be any issue.

1. In the customization of copy inspection results, maintain the inspection type in your plant.

2. In the inspection plan characteristics general data, maintain original results data as "preveous inspection lot"

Ading this link FYI..

[http://www.sdn.sap.com/irj/scn/go/portal/prtroot/docs/library/uuid/60221c69-0f8b-2b10-eebf-bec51a601dd6]