on 01-12-2012 5:41 AM
Hi,
This is MDM to JMS developement scenario.
Design part
mapping
i imported XSD structure both source and receiver sides. i done disign part...
Configuration part
i creat business system for both send and receiver. as well as communication channel also.
hear my problem is....
after communication chanel hace to creat
Senderaggrement
ReceiverAgreement
REceiverdetermination
interface determination
in sender aggrement, we have to select communication component and interface......hear i could not found the sender inter face.
in receiver aggrement also have to select the communication component and interface....hear interface is showing but it is showing (OA inter face ) mans sender side interface.
what could be the problem...
suggest me.
Thanks and regards,
Kesava
Hi,
IN ESR you have to Check the service interface is activated properly or not.
Coming to ID select the proper communication component and find the relevant SI.
regards,
ganesh.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
In sld they did not add the softsoftware component in sender side. thet's why it is not showing. is it right.
Regards,
kesava.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Check the Type of Interface given in ESR.
Try to add the interfaces to your Business systems, this also helps you.
Regards,
Anudeep.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi ganesh,
I checked ESR and id part...
In ESR SI part i activated.
Again it is showing same...
Thanks ,
Kesava.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Check the sender service interface category is OUTBOUND or not and which message type is assigned to the sender service interface is it sender message type or receiver message type and Same as receiver service interface also you have to check.
check the operation mapping what are service interfaces are assigned.
When we perform any changes to our design objects and configuration objects which were created in our IR and ID and if the changes were not reflected to that objects, at that time every one mind would point to perform the cache refresh. We have different options available to perform the cache refresh.
In IR from MenuàEnvironmentàClear SLD Data cache.
In ID from Menu ClearàEnvironmentàSLD Data Cache.
regards,
ganesh.
User | Count |
---|---|
87 | |
23 | |
11 | |
9 | |
8 | |
5 | |
5 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.