JMS to IDOC xslt mapping

[Former Member]

Hi,

We have a JMS to IDOC scenario. We are using PI7.1. We are currently using XSLT Mapping . This needs to be replaced by Graphical mapping as XSLT mapping is consuming more memory.

If we remove the XSLT Mapping between source and target would we need content conversion for the soruce file ?

Please advice.

Thanks,

Teresa

[baskar_gopalakrishnan2 · Accepted solution]

You are trying to replace XSLT mapping with message mapping. If your current source message is XML then why do you need to do content conversion? You simply map the xml jms message with receiver idoc.

[Former Member · Accepted solution]

That was my thinking too that if the source is an XML file then we do not need Content Conversion.

Thanks,

Teresa

[Former Member · Accepted solution]

Hi Teresa,

File Content conversion(fcc) is used to convert Any format file to XML format, while sending the data into PI.

& XML format to Any required output format, while sending data out of PI.

B'cos, PI only understands XML language.

So, this has nothing to do with XSLT mapping in your case.

change XSLT mapping to Graphical mapping. that should accomplish your task.

-santosh.

[former_member184681]

Hi Teresa,

This is one of important SAP PI strengths. If nothing changes on sender or receiver side, then the scope of the change is really small. All you need to do is to prepare your graphical Message Mapping, then go to your Operation Mapping and replace the XSLT mapping used so far with your new graphical one. Nothing else needs to be changed.

Hope this helps,

Grzegorz