A3 format print..

[Former Member]

Hi,

user want to print in A3 format. I created a format type called Z_DINA3 using standard format type DINA3. But when a give a print

in the properties i am selecting the Z_DINA3. but its saying "system is not able to print last 70 columns" can any body please help me

<< Priority normalized >>

Thanks in advance

Regards

Sagar.

Edited by: Rob Burbank on Jan 6, 2012 1:53 PM

[Former Member · Accepted solution]

Hi friend,

Just try reducing the size of data and try printing it. I think it might be the problem with that.

If its not printing with the small amount of data also then try changing the device settings.

It might be the problem.

Just check these two things and please revert back to me if you have any queries i will help you.

Thanks,

Sri Hari

[Former Member · Accepted solution]

Hi SriHari & Madhu,

Thank you for the reply. I am some where messed up while defining the format type and assigning the same to device type. can you guys please help me with the step by step procedure of assigning a format type to a device type and output device. I want to set a format type which can print A3.

Thank you

Regards

Sagar.

[madhu_vadlamani · Accepted solution]

Hi sagar,

Can you check the note sap note 2374.

Regards,

Madhu.

[Former Member · Accepted solution]

HI friend,

I think the tutorial below gives you the steps involved in the full process.

Please go through it and do it from start then you will be able to identify and correct your mistake.

Link: <link to blocked site removed by moderator>

If you still face queries revert back to me i will help you.

Because i used these steps during my requirement.

Thanks,

Sri Hari

Edited by: Thomas Zloch on Jan 9, 2012 2:36 PM

[Former Member]

Thank you guys my problem is solved.. Thanks a ton srihari and Madhu.

[madhu_vadlamani]

Hi Sagar,

Good.

Regards,

Madhu.

[madhu_vadlamani]

Hi Sagar,

Reduce the printed columns and see.If that will work fine else check the printer.

Regards,

Madhu.