cancel
Showing results for 
Search instead for 
Did you mean: 

Entry XXXX XXXX does not exist in T001L (check entry) Message no. 00058

Former Member
0 Kudos

Hi Friends,

While creating material in MM01, I'm getting an error as

Entry XXX XXX does not exist in T001L (check entry) Message no. 00058

Diagnosis

Input values must be defined in Table T001L. The value or values 'ZAN1 ZAN1 ' are not specified in this table

Procedure

Check whether the input is correct and correct if necessary.

Procedure for System Administration

If this is not an incorrect entry, check the system settings and change them if necessary.

If there is a connection to the Customizing system, you can maintain the system settings by choosing Customizing in the Performance Assistant or Maintain Entries (F5) when displaying the help in a modal dialog box.

I created the Sales Org, Distribution Channel, Division in SD and assigned them to one another. Still it's giving error and when I try to input Division & Distribution channel in initial screen of MM01 they're (my own Division & Distribution channel) not getting displayed in drop down list.

Can anyone please help me in this issue.

Thanks,

Pavan

Accepted Solutions (0)

Answers (6)

Answers (6)

Lakshmipathi
Active Contributor

You would not have assigned the storage location to plant which you can check in ox09

G. Lakshmipathi

0 Kudos

SPRO-> Materials Management->General Settings for MM->Requirement Prioritization->Assign Plants & Storage Locations

Follow this path and maintain your plant and storage locations

Former Member
0 Kudos

This message was moderated.

Former Member
0 Kudos

Hi Friends,

The Issue is resolved by doing the below stated step.

Go to SPRO-> Materials Management->General Settings for MM->Requirement Prioritization->Assign Plants & Storage Locations

Here you assign your Plant, Storage Location to one another and Save.

Thanks,

Pavan

0 Kudos

Hi Pavan,

Please refer to the following thread. Hope it helps.

Regards,

Sridhar

Former Member
0 Kudos

Maintain common dist channel and common division

SPRO>S&D>Master Data> Common Dist channel and Common Div

If you have not created new common Dist channel or division the maintain the same which you have defined.

and check storage location assignment