Recorded results not transferred to Original value-Qualitative Analysis

[Former Member]

Dear friends,

At present we are using ECC 6.0, where in QM - during result recording of Qualitative characteristics, selecting suitable catalogue Code. But that is no displaying in column "Original Value".

Can you please suggest solution of this query ?

Thanks.

Prakash Ravalia

[Former Member · Accepted solution]

Hi the same is getting discussed in the following thread.. you can try the suggestions in the following thread.

[;

[Former Member · Accepted solution]

Hii,

Please check the Control indicator for the MIC. If it is single result recording the the system can not derive the final result from the indivisual ones so it ll not update the original values . So try to use MIC as summerized recording and in selected set put the valuation code for each code.

Regards,

Smruti

[Former Member · Accepted solution]

Hi.. Smruti,

Thanks for suggestion on my QM query, but still probm is there. I have checked about Control indicator setting - it is as Summarized Result. Also at Selected set, code group - code is maintained with Valuation code.

Any other reason for not showing Original Value ?

Prakash Ravalia

[Former Member · Accepted solution]

What is sample size ... ?

[Former Member · Accepted solution]

Sample size is... 1

[Former Member · Accepted solution]

That's a reason.

Try with more than sample size

[Former Member · Accepted solution]

Dear Sujit,

Thx... but not succeed. I have changed QDV3 Sampling procedure, where Sample size put as 2 & then created fresh Insp. Lot. But still not displaying Original Value for Qualitataive tests.

Regards,

Prakash Ravalia