on 12-20-2011 10:09 AM
Hi Expert,
I am doing the scenario where I have created Alert category named as Alert_cat
Now for Alert_cat i have created a rule for integration engine and in the setting "where did the error occur" I have given "Intergration engine".
Now for same Alert_cat,as discussed in the varios blog I have created many other rules each for various adapter,and in the setting "where did the error occur" I have given "Adapter engine".
I have tested it, above mentioned configuration is working for message mapping error (sxmb_moni)
but not for any error in adapter engine for messages in waiting or system error status.
Kindly suggest where I am going wrong.
Regards
Shefali S
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Ravi,
I have done all these configuration,that is why I am getting alert for messages stuck in Integration engine.
But I am not getting alert for messages stuck in Message monitoring in status Wait or System error.
Is there any other configuration required for messages stuck in status "Wait" or "System error" in Message monitoring in adapter engine.
Regards
Shefali S
Hi Shefali,
Have you set the rule as Active?
Regards,
Jenny
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Expert.
I read the forum link mentioned by you earlier also and after that I have found the below mentioned link.
I tried according to this link, but it is not working.
Can you please suggest me any method to capture errorneous message in Adapter engine,that is messages in Wait or system error status in message monitoring.
Regards
Shefali S
User | Count |
---|---|
87 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.