on 12-14-2011 7:43 AM
Hi ,
While doing the Result Recording system is giving the Pop up message for "Manual Valuation - Accept/Reject". This is hapenning while doing only some inspection lot. I want to know why this pop is coming ?
Settings i checked :-
1. MIC has Sampling procedure tick in control indicators
2. Assigned Sampling procedue has valuation mode :- Attributive Inspection nonconf. units
3. Configuration for "Plant Dep QM settings" - Result recording - Recording Configuration - close ,navigate,save automatically
The only difference i noticed between Inspection plans for which Manual Valuation pop up appear & do automatically is "Origin results data- Previous inspection lot" maintained in the plan for Manual Valuation pop up ..not sure if that could be possible reason
Kindly suggest if anything i am missing
Thanks
Ishwar
This message was moderated.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Pleasae remove the "Results Origin" setting. Then, it will work. Regards, Krishnam
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
If the results were copied from the previous inspn lot, the "Origin Results data" might be binding on the evaluation. That's what I thought - when I replied to your query.
Now, it seems: I was mistaken. This field is only for information purpose only and has no controlling function.
However, pl. try making this change and see.. if it works! Regards, KrishnaM
Hi,
If the results were copied from the previous inspn lot, the "Origin Results data" might be binding on the evaluation. That's what I thought - when I replied to your query.
Now, it seems: I was mistaken. This field is only for information purpose only and has no controlling function.
However, pl. try making this change and see.. if it works! Regards, KrishnaM
Hi Guru,
Sampling procedure
Sampling type is fixed , valuation method is Attributive inspection nonconf units
Without inspection points , use in inspection plan is ticked & base sample qty is 1
We using same sampling procedure for all Inspection so i think there is no issue in sampling procedure
Thanks,
Ishwar
Hi,
Pleasae remove the "Results Origin" setting. Then, it will work. Regards, Krishnam
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
96 | |
10 | |
9 | |
6 | |
3 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.