on 12-07-2011 7:02 AM
Hello,
I have installed a SAP Netweaver 7.3 AS JAVA and I would like to connect this JAVA Instance with 3 ABAP Systems (ECC 6.0) .
On help.sap.com I have found the following instructions: http://help.sap.com/saphelp_nwpi71/helpdata/en/3b/0c4b428f96ab53e10000000a1550b0/content.htm
Could you please advise, if the above configuration steps are OK?
Or could you please help me with the exact procedure?
Thank you in advance!
Noemi
Hi,
The steps mentioned in the link shared by you are very correct. You need to follow the same.
Regards,
Deepak Kori
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello Deepak, Hello Ventsi,
Thank you for your advices and help.
I managed to do the configuration as Deepak confirmed.
Best regards,
Noemi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Noemi,
I'm not sure how exactly you want to use ABAP and Java so it is hard to answer your question.
The link that you posted describes the steps to configure ABAP as a Security Assertion Markup Language (SAML) service provider. As a service provider, the AS ABAP enables you to off-load the authentication of users onto an identity provider. The identity provider enables you to federate identities across domains for Single Sign-On (SSO).
Check the following wiki page for a good overview of all the ways that you could connect to ABAP
http://wiki.sdn.sap.com/wiki/display/ABAPConn/ABAPConnectivityHome
Regards,
Ventsi Tsachev
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
90 | |
10 | |
10 | |
10 | |
7 | |
7 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.