on 12-06-2011 11:23 PM
Hi Expert,
I have a proxy to file scenario. I am using integrated configuration in PI 7.3. In sender proxy CC, I used SOAP adapter type, XI 3.0 message protocol. In file receiver CC, I set it as normal. I checked every step in Integrated Configuration. When I send message from R3 proxy side, I checked message monitoring in R3, it sent out successful. But when I check sxmb_moni in PI, I got an error saying "No receiver could be determined". Can anybody throw me a light on where the issue is?
Thanks,
Charles
Hello,
But when I check sxmb_moni in PI, I got an error saying "No receiver could be determined". Can anybody throw me a light on where the issue is?
Have you followed the SAP How To Guide "How to Set Up the Communication between ABAP Backend and SOAP Adapter using XI Protocol"
http://www.sdn.sap.com/irj/scn/index?rid=/library/uuid/70066f78-7794-2c10-2e8c-cb967cef407b
Have you also checked the ID cache for successful activation by going to ID -> Environment -> Cache Status?
Hope this helps,
Mark
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Mark,
Thank you for the link. It is very helpful. I did not set up Sender ID in R3 sender side and did not set sap.com/com.sap.aii.af.soapadapter/XISOAPAdapterBean to sender proxy CC. However, after I followed the procedure, I still got the same error in PI sxmb_moni. I also clean and check the cache. Do you know if there is anywhere else I miss something?
Thanks,
Charles
This message was moderated.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.