Result recording not flowing value to batch Classification -reg

[Former Member]

Hi,

Initially QM Lot result recording was flowing value to batch characteristic(BC ) A of the Batch .

As required we have developed object dependency for that BC A that if it is empty it should get value copied from the corresponding another BC B and if it has value then if the corresponding BC B value is latest then it should get copied to the BC A.

After this when we check the developed object dependencies are working firne through MSN2N .

Now the issue when a QM lot is created and result recording is done for the MIC to which BC A is linked , the value is not getting updated in the Batch .As per the dependencies also since the value B got updated older , it should not copy to A but the value updated at result recording should get updated in the batch .

Can some one throw some inputs on this

Regards,

Madhu Kiran

[vasudevap_pushpalas]

Dear

Please check in QE51N there u find the Inspection lot through batch ull do after recording complete when u go to QA11 with inspection lot there u find the batch status when u click on that u get the desire batch

in MSC2N if u have a new value for that batch just click on the classification tab click on that u ll get the values

With Regards

pushpalas

[Former Member]

Hi,

We do result recording through QA02--Results ---which is same as QE51N

We do Usage decision then through QA02...Usage decision ---which is same as QA11

The issue is that the result recording value of the MIC (MIC is linked to Batch Characteristic) is not getting updated in the Characteristic Value of the Batch assigned to the inspection lot subsequent to the dependency maintained to the characteristic as detailed above.

We also would like to know after results recording and SAVE ---how the result recording value is transfered to the BC linked to the MIC for which value is recorded . Is there any FM, BAdi ,BApi etc... to transfer these results to batches

Regards,

Madhu Kiran