Error in communication channel

[Former Member]

File is not getting picked up from the source and

We checked ftp path and file names those are fine and also communication channel is active mode.

thanks

phani....

[Former Member · Accepted solution]

Hi,

1. Did you try stopping and starting the communication channel from runtime workbench--> adapter monitoring --> communication cahnnel monitoring for your sender communication channel.

Also you can give a try by inactivating and activating the file sender communication channel in ID.

2. The File Service alone can be restarted from Visual Admin or Netweaver Administrator. It could be done in seconds.

to start and stop the service in visual administration. Login into visual administrator --> system id --> services --> SAP XI Adapter File --> right click on it and you have stop and start options. Stop it from there and restart it.

3.your communication channel might be locked and which needs to be unlocked. thatu2019s why it is showing polling but not actually picking any file..

in your case also it might be the same case try to check that there is no communication channel locked. you may need to contact basis or PI administrator..

if any lock .. remove the lock then stop and start your communication channel and it should work properly.

regards,

ganesh.

[former_member183898]

Hi Phani,

IF channels are working fine and everything is ok. Check the Source directory path mentioned in the channel.

Sometimes it get entered incorrectly,.

Thanks,

Pushkar

[Former Member]

apart from the above options you can try some of the below:

1. STOP and RESTART the channel. since some time the file chanel becomes isolated and the handshaking doesn't happen properly.

2. you should always give a "time out" in the sender channel.

3. Also when you pick up your file using some wincscp/filezilla tool, change the property of the file as read, write and delete. i.e change to 0777.

[Former Member]

Hello,

Check the following.

1. Whether the ftp location is accessible from XI server, using internet explorer or command mode

2. In communication channel monitoring (RWB) what is the status message (is it saying: Properly configured)

3. Try and restart the communication channel

4. Check the polling interval set to

regards

Ramesh

[Former Member]

hi,

you need to check below points:

1. cache status

2. In administration, there is any lock for communication channel.

thanks,

[Former Member]

Hi,

Check file exists in the source folder, User (mentioned in sender CC) having enough priviliges to pick the file from source folder.

Check the status of CC, if you are not getting any status then check the status at OS level (basis will help us) based on that status we can proceed further.

Regards,

Venkata Ramesh