on 11-23-2011 11:40 AM
Dear All
I have a scenario where my material type is Semifin and I have set up inspection type 03 that is inprocess inspection at the time of operation 10 20 30 40 u2026 so on during operation 10 I found there is some problem or operation not done properly at that what should i do where I should send this material and what exact steps involved during operation problem
Please advise me
With regards
Pushpalas
hi,
This is in-process scenario, if u found that operation 10 get wrong than u transfer the material from next operation i.e. 20 to previous operation.i.e 10, based on quality results and feed the notification against process error via 10 and again process the operation 10 w.r.t same Process order.
Regards
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
97 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.