on 11-15-2011 11:33 AM
Hi,
can any body tell me where to do the configuration settings for decimal places in master inspection characteristics
i want my limits to be 1.234
i want 3 decimals after point
Regards,
Raj
Set the decimals under Quant data of MIC or IC in Quality Plan.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
If you have assigned a class characteristic to your MIC, then you can go to the General data tab of that Class characteristic and define how many decimal places you want.
Or you can go to QS21 or QS23 and click on the Quant Data button there, enter the Decimal places.
Regards,
Vinodh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Please go through the below link.
http://www.freesaptutorial.com/how-to-create-master-inspection-characteristic-in-sap-qm-module/
While creating the MIC in QS21 after entering the control indicators you will get Quantitative data screen.
In that screen you can enter the decimal places, UOM, target, lower limits etc
Regards
Hari
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.