on 11-11-2011 7:57 AM
Hi
Create a Default Final demand macro which calculates all the keyfgiues then tried to release to snp but it is not release, when i see the value is there in final demand plan but when i trigger this final demand plan in background then release to snp it is releasing fine ,the selection profile used in both thing is same ,can you please let me know why default macro is not working to release to snp
Regards
kkk
Hello,
For your final demand plan key figure, please make sure that you;'re using a time series key figure instead of an auxiliary key figure. No matter the macro and release are executed in background or foreground, the important thing is that, before release process runs, the claculated final demand plan must be already saved to liveCache.
Best Regards,
Ada
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi KKK,
For any calculation to be done, the macro should be executed. Even if it is a default macro, at least one time the selection should be loaded in the planning book to make the macro to execute. Please load your selection once in planning book and check whether the final demand is calculating automatically. Then save the results. Exit the planning book. Once again load the planning book and check whether the saved final demand values exist. If exists, then try to release it to SNP.
Please check and revert.
Regards,
Manimaran M.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
7 | |
4 | |
3 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.