Alerts not triggering

[v_veeramalla]

Hi Team,

WE configured message based monitorining for our PI system and it's working fine, but it's not working if i use sender and receiver party/component names.

I have given the restriction as below.

Sender Party :- given sender component name

Sender Service: *

Sender Interface: given sender interface name

Sender Name space: *

Receiver Party:- given receiver component Name

Receiver Service:*

Receiver Interface : *

Receiver Name space: *

Please let me know the best way to filter the alerts.

Thanks in Advance

Regards

Veeramalla

[Former Member]

Veeramalla

Please check whether you are talking about Party or service.

in case of service (Component) use as follows:

Sender Party :

Sender Service: given sender component name

Sender Interface: given sender interface name

Sender Name space: *

Receiver Party:

Receiver Service: given sender component name

Receiver Interface : *

Receiver Name space: *

Regards

Raj

[v_veeramalla]

Hi,

Sorry for the confusion created by me, actually iam a basis consultant not PI. I took the values from RWB . I got sendercomponet information in RWB but i did not found sender component in alert configuration . I think by mistake i used sender component information as sender party in alert configuration.

Regards

Veeramalla.

[v_veeramalla]

HI Again,

Is there any way to reset the Alert ID count ?

Regards

Veeramalla

[Former Member]

have u given values for party or service??