Tolerence Key

[lakshmi_prasad7]

how to use tolerence key for specific % purpose in result recording means i have the lower and Upper values with tolarence + or - 5 to 10 percentage any body done this business kindly suggest..

[lakshmi_prasad7]

Thank you very for input

[Former Member]

Infact tolerance keys are specified during creation of MIC & not during result recording.

These Keys are defined as the the std Shaft & hole basis ( mechanical design terms) for fits & tolerences.

Depending upon the tol keys uppers & low limit changes as per ISO 286.

Refer for a example.

[lakshmi_prasad7]

Thank You very much for in your input but actual my requirement is any provision is there i enter % of tolerence in characteristic level

[krishnamurty_madduri]

Hi,

Just to add: While creating the MIC, please create the tolerance limit in % as required. The same will be copied in to the inspection plan, when you use this MIC in it. In case, you want to change the tolerance limit/UOM, you can change it in the Inspection plan. Regards, KrishnaM