on 08-29-2006 5:22 PM
Can some tell me where to find the Navigation Point connector? The only connectors that I see are Start, End, Signal In, Signal Out, Popup Signal, Timer, User Data and Data Store. I am using VC7 SP8 (700.8.0.1).
Hi,
I am also using the same version. I am able to see 'Navigate' connector after 'End' in the 'Compose' Task panel.
Open an iView and check the Compose Task Panel
Thanks,
Ramakrishna
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
There is no need to install the SP again, the problem here is that the navigate connector is only available when using webdynpro as the compiler, it is not available when using flash.
To change the compiler you have to go to tools>>options>>compiler.
I hope you did not reinstall the SP.
Jarrod Williams
Aha! I didn't notice in any of the documentation that some connectors were only valid for a specific complier. It would be helpful if the VC reference guide indicated this. Unfortunately, now I'll have to chose between Navigate and Popup connectors.
Thanks for your help Jarrod. No, I did not re-install the SP.
User | Count |
---|---|
84 | |
25 | |
12 | |
9 | |
6 | |
6 | |
5 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.