on 09-28-2011 9:54 AM
Dear Gurus,
I am tying to change the customer master data. But after entering customer number i get a dump- Dynpro does not exist.
I tried to search notes using below terms but could not got relevant note.
"DYNPRO_NOT_FOUND" " "
"SAPLSZA1" or " "
"SYSTEM-EXIT"
what needs to be done to avoid the Dumps
Rgds,
Saurabh
note 1898691
Regards,
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi!
I have the same problem. It is possible to correct this? This is not working only for a specific client. This client exist but the information about him is reduced, only two or three fields are filled.
Regards,
Gilberto
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Saurabh,
Check note: 1225492.
Also check with your ABAP consultant.
Regards,
Raghu.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
With a BAPI program it can be set,try this BAPI_CUSTOMER_CHANGEFROMDATA1.
Thanks
Ram
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
99 | |
11 | |
10 | |
6 | |
5 | |
5 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.