on 09-24-2011 6:50 AM
Dear,
I have taken te following setting and also change the setting. But result don't copy from previous lot. Though I have set in inspection plan for every MIC Origin results data = 02 Previous Inspection Lot.
SPRO Setting:
Control in Insp. Lot - 2 Automatic Data Transfer at Sample Calculation.
Control in RR - 2 Automatic Data Transfer When accessing Results Recording
Close - Make Tick mark
Origin TL - No setting
DatOrig.RR - 02
Selection - 300
Mapping - 100
Log - Make Tick mark
After putting the previous lot no then error comes out. Error is given below:
Error: Data selection procedure 300 could not find any data
Plz give me solution......
Hi,
Make Origin TL = 2 and check once again.
Further, worth to go thru F1 help for field: Control in Insp. Lot.
Regards,
Tanuj Parikh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
91 | |
11 | |
10 | |
6 | |
5 | |
5 | |
5 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.