Table T000 was not relevant for conversion in BDLS log

[Former Member]

Hi All,

I am getting the below message in BDLS log while doing logical system system conversion with BDLS.

"Table T000 was not relevant for conversion"

Due to this I could see old logical system entry in SCC4 instead of New converted logical entry.

(I've gone through the forums ,but didn't find solution)

Any Idea why I am getting this message and I triggered BDLS from client 000.

Regards,

Srinivas Chapa.

[michael_ruth3 · Accepted solution]

Srini,

check dd02l table, if the field CLIDEP is x then those tables are client dependent or check SE11 and if MANDT is there in table T0000, then it is client dependent.

Cheers,

Michael

[Former Member · Accepted solution]

Hello,

It is always recommeded to run the BDLS in the active client rather than 000 or any other.

Regards,

Mudasir H Syed.

[JPReyes]

I think you need to define and assign a new logical system in SALE for SCC4 and then execure BDLS

Regards

Juan

[Former Member]

Already SCC4 entry for the client has old Logical system name.

Ex:

Client 500

Logical System : <PRD>CLNT500

I need this to be change to <QAS>CLNT500 after BDLS,but it is not happening after BDLs.

Regards,

Srinivas Chapa.

[Former Member]

Hello,

Thanks

[Former Member]

Is BDLS client specific?

-Srini Chapa

[Former Member]

'Is BDLS client specific?'

Conversion takes place in the current client where BDLS runs.

Thanks

[Former Member]

Thanks to all for letting me know the required information

Regards,

Srini Chapa.